Bending Branches Angler Classic, Angler Ace and Angler Pro fishing kayak paddle blades

Bending Branches Fishing Paddles: Angler Classic, Angler Ace and Angler Pro, Snap-Button and Versa-Lok

Caney Fork Outdoors

Bending Branches builds three fishing paddles that cover almost every kayak angler: the Bending Branches Angler Classic, the Bending Branches Angler Ace and the Bending Branches Angler Pro. All three share the same oversized fishing blade shape, the built-in hook retrieval notch, the 40 inch tape measure printed on the shaft, and a two-year warranty. They are hand built in Osceola, Wisconsin. What separates them is shaft material, blade material and weight, and that is what you are paying for as you move up.

Each one also comes in two shaft styles, Snap-Button and Versa-Lok, and the Angler Pro adds a third, Posi-Lok. The ferrule decides whether your paddle is one fixed length or adjusts 15 cm, and whether feather is two angles or any angle. Pick the paddle first, then the ferrule.

Videos

Official Angler Pro product video from Bending Branches

What all three share

The fishing blade is bigger than a touring blade on purpose. A loaded fishing kayak with a high seat and a crate takes more to move than a bare recreational kayak, and the 7.5 by 18 inch blade puts enough water behind each stroke to move it without flutter. Every shaft is ovalized where your hands sit, which keeps your grip indexed without looking and cuts down on blisters over a long day.

The hook retrieval notch is molded into the blade. When a lure hangs in a laydown you cannot reach, the notch hooks the line and works the lure free instead of breaking off and retying. The 40 inch tape measure runs down the shaft so you can check a fish against a slot limit on the spot. Bending Branches calls it a sizing guide rather than an official measuring tool, so a tournament fish still goes on the board.

Bending Branches Angler Classic

The Angler Classic is the best seller in the line and the paddle most kayak anglers start with. The shaft is 100 percent fiberglass, which is lighter than aluminum, warmer in the hands on a cold morning, and flexible enough to take some of the shock out of a hard stroke. The blades are fiberglass-reinforced nylon, built with a little forgiveness and the right amount of flex to keep a gear-loaded kayak moving.

Weight is 35.5 ounces in Snap-Button and 37 ounces in Versa-Lok. A carbon ferrule insert at the joint is the same upgrade the carbon shaft paddles get, so the connection stays tight for years.

  • Shaft: 100% fiberglass
  • Blade: Fiberglass-reinforced nylon, 7.5 x 18 in, 102.5 sq in
  • Weight: 35.5 oz Snap-Button, 37 oz Versa-Lok
  • Snap-Button lengths: 240, 250, 260, 270, 280 cm
  • Versa-Lok lengths: 240-255, 250-265, 260-275 cm
  • Warranty: 2-year manufacturing

Shop it as the Bending Branches Angler Classic Snap-Button Fishing Kayak Paddle or the Bending Branches Angler Classic Versa-Lok Fishing Kayak Paddle.

Bending Branches Angler Ace

The Angler Ace is the value step up. The shaft moves to 100 percent carbon, the lightest material Bending Branches uses, with a tight, secure weave. The blades move to carbon-reinforced nylon, which is the most durable blade in the line. Bending Branches designed it to take a beating against rocks, ramps and gunwales while putting more torque behind each stroke for a loaded kayak.

Weight drops to 30.5 ounces in Snap-Button and 32 ounces in Versa-Lok. Five ounces off the Classic does not sound like much until you count strokes over a long day. The Ace is the paddle for anglers who fish hard, beat on their gear and want carbon without paying for a compression molded blade.

  • Shaft: 100% carbon
  • Blade: Carbon-reinforced nylon, 7.5 x 18 in, 102.5 sq in
  • Weight: 30.5 oz Snap-Button, 32 oz Versa-Lok
  • Snap-Button lengths: 240, 250, 260, 270, 280 cm
  • Versa-Lok lengths: 240-255, 250-265, 260-275 cm
  • Warranty: 2-year manufacturing

Shop it as the Bending Branches Angler Ace Snap-Button Fishing Kayak Paddle or the Bending Branches Angler Ace Versa-Lok Fishing Kayak Paddle.

Bending Branches Angler Pro

The Angler Pro is the paddle the Bending Branches ProStaff and competitive anglers fish with, and it has taken Angler Paddle of the Year six times in the YakAngler consumer awards. The shaft is 100 percent carbon. The blades are compression molded fiberglass, which is where the weight savings and the longevity come from. A cross dimensional fiber weave gives them a slight amount of flex, and the blade shape is built for a silky-smooth forward stroke with zero tolerance for flutter. Over a long day that is energy you keep.

The blade runs 7.25 by 18 inches at 105 square inches, a touch bigger than the Classic and Ace, and the blade patterns are designed and selected by the ProStaff and Ambassador teams. Weight is 28.5 ounces in Snap-Button, 29 ounces in Posi-Lok and 30 ounces in Versa-Lok. The Posi-Lok version also carries Lam-Lok edge protection and aramid in the blade for the anglers who are hardest on their gear.

  • Shaft: 100% carbon
  • Blade: Compression molded fiberglass, 7.25 x 18 in, 105 sq in (fiberglass with aramid on Posi-Lok)
  • Weight: 28.5 oz Snap-Button, 29 oz Posi-Lok, 30 oz Versa-Lok
  • Snap-Button and Posi-Lok lengths: 240, 250, 260, 270, 280 cm
  • Versa-Lok lengths: 240-255, 250-265, 260-275 cm
  • Warranty: 2-year manufacturing

Shop it as the Bending Branches Angler Pro Snap-Button Fishing Kayak Paddle, the Bending Branches Angler Pro Versa-Lok Fishing Kayak Paddle or the Bending Branches Angler Pro Posi-Lok Fishing Kayak Paddle. The Bending Branches Angler Pro Carbon Versa-Lok Fishing Kayak Paddle and Bending Branches Angler Pro Carbon Posi-Lok Fishing Kayak Paddle put carbon blades on the same carbon shaft. We reviewed the Angler Pro Versa-Lok on its own in October.

Snap-Button: fixed length, two angles, the simplest joint

The Snap-Button ferrule is the one most paddlers know. A spring button on one half of the shaft snaps into one of three holes on the other half, which gives you 0 degrees of feather or 60 degrees left or right. Length is fixed at whatever you ordered: 240, 250, 260, 270 or 280 cm.

What you get for giving up adjustment is the strongest, simplest connection Bending Branches builds. There is nothing to clamp, nothing to loosen and nothing to corrode. The carbon ferrule insert keeps the two halves snug, so there is no wobble at the joint like a commodity paddle develops. If you fish one kayak at one seat height and you know your length, Snap-Button is the lightest and cheapest way into each of the three paddles.

Versa-Lok: 15 cm of length and any feather angle

Versa-Lok replaces the button with a clamping collar. Loosen it and the two halves slide, which gives you 15 cm of length adjustment inside the range you bought: 240 to 255, 250 to 265 or 260 to 275 cm. The same collar sets feather at any angle rather than two fixed holes.

Bending Branches built it for wider kayaks and elevated seating positions, which describes most fishing kayaks. Drop the seat to the low position to paddle into wind and shorten the paddle 5 cm. Stand up to cast and run it long. Share it with a shorter paddler and change it in ten seconds. The collar is nylon and stainless steel, corrosion-resistant, and backed by structural and cyclical testing plus a decade of on-water use. It costs about an ounce and a half over Snap-Button on each paddle.

On the Angler Classic, Versa-Lok is the version to take if you fish more than one kayak or want a feather angle other than 0 or 60. On the Angler Ace the same holds, with carbon under your hands. On the Angler Pro, Versa-Lok is the one the Pro Staff reach for.

Posi-Lok on the Angler Pro

The Angler Pro adds a third option. Posi-Lok is fixed length like Snap-Button, with a dual-button release that indexes feather in 15 degree steps left and right instead of two fixed holes. It is the pick for a paddler who wants a specific feather angle, say 30 or 45 degrees, and never needs to change length. The Posi-Lok Angler Pro is also the one that carries Lam-Lok edge protection, Bending Branches' patent pending edge guard that extends the life of the blade, and compression molded fiberglass with aramid in it.

Which ferrule for which paddler

The question that decides it is whether your paddle length ever changes. One kayak, one seat height, one paddler: Snap-Button, and spend the savings on the next paddle up. Two kayaks, a hi-low seat you actually use, or a paddle that gets shared: Versa-Lok. Angler Pro with a feather angle you have dialed in: Posi-Lok.

For length itself, our kayak paddle sizing guide covers the numbers. The short version from Bending Branches' own fishing paddle sizing: most fishing kayaks land between 240 and 260 cm, a 5 foot 8 paddler in a 32 inch kayak sits at 250 cm, and a high seat adds 10 cm. If you are between two sizes, Versa-Lok removes the guess.

Specifications

  • Angler Classic: Fiberglass shaft, fiberglass-reinforced nylon blade, 35.5 oz Snap-Button, 37 oz Versa-Lok
  • Angler Ace: Carbon shaft, carbon-reinforced nylon blade, 30.5 oz Snap-Button, 32 oz Versa-Lok
  • Angler Pro: Carbon shaft, compression molded fiberglass blade, 28.5 oz Snap-Button, 29 oz Posi-Lok, 30 oz Versa-Lok
  • Blade Size: 7.5 x 18 in (102.5 sq in) on Classic and Ace, 7.25 x 18 in (105 sq in) on Pro
  • Snap-Button: Fixed length, 0 and 60 degree feather, 3-hole
  • Versa-Lok: 15 cm adjustable length, infinite feather
  • Posi-Lok: Fixed length, 15 degree feather increments, dual-button release
  • Fixed Lengths: 240, 250, 260, 270, 280 cm
  • Versa-Lok Ranges: 240-255, 250-265, 260-275 cm
  • Warranty: 2-year manufacturing on all three
  • Made In: Osceola, Wisconsin, USA

Key Features

  • Oversized Fishing Blade: Built to move a loaded kayak without flutter.
  • Built-In Hook Retrieval: Work a snagged lure free instead of breaking off.
  • 40-Inch Tape Measure: Printed on the shaft to check a fish on the spot.
  • Ovalized Grip: Indexed hands, fewer blisters.
  • Carbon Ferrule Insert: A tight joint on every ferrule type.
  • Fiberglass to Carbon: Classic, Ace and Pro step up in shaft and blade material.
  • Snap-Button: The simplest, strongest connection.
  • Versa-Lok: One paddle that fits two kayaks and two seat heights.
  • Posi-Lok: Feather in 15 degree steps, with Lam-Lok edge protection on the Pro.
  • Hand Built in Wisconsin: Two-year warranty on all of them.

Every one of these ships parcel, so the paddle usually shows up before the kayak does. If you are sizing one for a specific kayak, call us at (615) 696-7887 with the kayak and your height and we will put you in the right length.

Bending Branches Fishing Paddle Questions, Answered

What is the difference between the Angler Classic, Angler Ace and Angler Pro?

Materials and weight. The Classic is a fiberglass shaft with fiberglass-reinforced nylon blades at 35.5 ounces. The Ace is a carbon shaft with carbon-reinforced nylon blades at 30.5 ounces. The Pro is a carbon shaft with compression molded fiberglass blades at 28.5 ounces. All three share the fishing blade shape, the hook retrieval notch and the tape measure.

What is the difference between Snap-Button and Versa-Lok?

Snap-Button is fixed length with a spring button that sets feather at 0 or 60 degrees. Versa-Lok is a clamping collar that adjusts length 15 cm and sets feather at any angle. Versa-Lok weighs about an ounce and a half more on each paddle.

Is Versa-Lok worth it over Snap-Button?

If you fish more than one kayak, use both positions on a hi-low seat, share the paddle or want a feather angle other than 0 or 60, yes. If you fish one kayak at one height and know your length, Snap-Button is lighter and simpler.

What does Posi-Lok do?

It is a fixed-length ferrule with a dual-button release that indexes feather in 15 degree steps left and right. Bending Branches offers it on the Angler Pro, where it also brings Lam-Lok edge protection and aramid in the blade.

What length Bending Branches fishing paddle do I need?

Most fishing kayaks land between 240 and 260 cm. A 5 foot 8 paddler in a 32 inch wide kayak sits at 250 cm, and a high seat position adds 10 cm. Wider kayaks and taller paddlers go longer. Versa-Lok ranges cover two sizes at once if you are between them.

Will the Versa-Lok collar loosen or corrode?

Bending Branches built it from nylon and stainless steel parts, calls it corrosion-resistant, and backs the clamping system with structural and cyclical testing plus a decade of on-water use. A carbon ferrule insert keeps the joint tight.

Can I measure a legal fish with the tape on the shaft?

Use it as a sizing guide. Bending Branches states it is not an official measuring tool for competitive angling or for determining the legality of a catch, since printing can vary slightly from the manufacturing process.

How do the Bending Branches Angler paddles ship?

Ships parcel, nationwide. Each one breaks down into two pieces and boxes up, so it goes out as a standard ground shipment.

Previous Next