Native Watercraft Falcon 11 Review
The Native Watercraft Falcon 11 is the way into Native without a pedal drive. Eleven feet long, 32.5 inches wide, 60 pounds for the fitted hull and 65 pounds fully rigged, and it paddles. Everything else in the Native fishing line is built around a Propel drive. The Falcon 11 is the one you can lift onto a roof rack by yourself, carry to a pond on a cart, and fish without a battery or a drive to look after.
What it keeps is the fishing hardware most kayaks drop at this size. A console with battery storage and transducer access, a transducer mounting plate on the hull, a console cover that carries gear track for a fish finder, dual flush mount rod holders, and hi-low frame seating. Native builds it in the USA.
Videos
Native Watercraft Falcon 11
Sixty pounds changes how often you fish
Native publishes two weights for the Falcon 11: 60 pounds for the fitted hull and 65 pounds fully rigged. The 65 is the number you lift. For comparison, the pedal kayaks in the Native line run well past 100 pounds once the drive and seat are in, and most of them want a trailer or a second set of hands. The Falcon 11 goes on a roof rack, a bed rack or a hitch hauler one person at a time, and it comes back off the same way at the end of a long day.
That is the whole case for a paddle kayak in a pedal brand's lineup. The kayak that loads in two minutes gets fished on a weeknight. The one that needs a plan gets fished on a weekend.
Hi-low frame seating
The Falcon 11 runs a frame seat with two heights. High puts your eyes above the water for sight fishing and lifts you out of the puddle a sit on top collects. Low drops your center of gravity for paddling into wind, and it is the position you want when the water gets choppy. Switching between them takes a few seconds and no tools.
Adjustable foot rests sit ahead of the seat, so the kayak fits the paddler rather than the other way around. Stand-up pads are molded into the deck where your feet land when you get up to cast.
Built for a fish finder from the start
This is where the Falcon 11 separates from other paddle kayaks at its size. Native put a transducer mounting plate on the hull, so the transducer bolts on without drilling. The console in front of the seat holds the battery and gives you access to run the transducer cable. The console cover carries a section of gear track, which is where the display mounts. Buy the kayak, buy the unit, and the install is a morning rather than a project.
A bow hatch opens into the hull, which gives you dry storage up front and a way to get at wiring if you route it inside. Six scupper plugs come in the box, so you can seal the deck on cold mornings or when you are carrying weight.
Deck hardware
Two flush mount rod holders sit behind the seat. A side mounted paddle clip holds the paddle along the gunwale while you fish, so it stays out of your lap and out of the water. A water bottle bungee sits within reach. Groove track runs along the deck for mounting rod holders, a camera or a cup holder without drilling.
The carry handles are molded for a one-person lift, and the stern has a replaceable skid plate. Dragging a kayak up a gravel ramp is normal use, and the plate takes that wear so the hull does not. When it is worn through, you swap the plate.
Getting it to the water
The Falcon 11 is groove-track equipped and Sidekick ready. The Native Watercraft Sidekick Wheel Transport System Kayak Cart mounts to the kayak itself, so the wheels ride along rather than being a second thing to carry back from the launch. At 65 pounds rigged, a lot of Falcon 11 owners skip a cart entirely and carry it. The Sidekick is for the long walk from a parking lot or a campsite.
For a paddle, the Falcon 11 is 32.5 inches wide with a seat that sits high, which puts most paddlers in a 240 to 250 cm fishing paddle. The kayak paddle sizing guide walks through the numbers, and the Bending Branches Angler Classic Snap-Button Fishing Kayak Paddle is the one most people put with it.
Specifications
- Length: 11 ft / 335 cm
- Width: 32.5 in / 83 cm
- Depth at Beam: 15.84 in / 40 cm
- Fitted Hull Weight: 60 lbs / 27.2 kg
- Fully Rigged Weight: 65 lbs / 29.4 kg
- Capacity: 325 lbs / 147.4 kg
- Propulsion: Paddle
- Seat: Hi-low frame seating
- Rod Holders: Dual flush mount
- Transducer: Hull mounting plate, console access
- Scupper Plugs: Six included
- Skid Plate: Replaceable
- Made In: USA
Key Features
- 60 lbs Fitted Hull: The lightest kayak Native builds. One person loads it.
- Paddle Powered: No drive to service, winterize or replace.
- Transducer Plate on the Hull: Fish finder ready without drilling.
- Console With Battery Storage: Transducer access inside, gear track on the cover for the display.
- Hi-Low Frame Seating: Sit high to see and cast, drop low to paddle.
- Stand-Up Pads: Molded into the deck where your feet land.
- Bow Hatch: Opens into the hull for dry storage and wiring access.
- Dual Flush Mount Rod Holders: Plus a side mounted paddle clip.
- Groove Track: Mount accessories without drilling. Sidekick ready.
- Adjustable Foot Rests: The kayak fits the paddler.
- Replaceable Skid Plate: The part that wears is the part you can swap.
- Six Scupper Plugs: In the box.
Where it sits in the Native line
Every other Native fishing kayak we carry runs the Propel pedal drive. The Native Watercraft Slayer Propel 10 LTE Pedal Kayak is the closest in size, with the drive under the seat and a 425 pound capacity for paddlers who want to carry more. The Native Watercraft Titan X Propel 10.5 Pedal Kayak is the wider standing platform with the drive.
The Native Hammer 1210
The Native Watercraft Hammer 1210 Propel Pedal Kayak is Native's newest kayak and the other end of the line from the Falcon 11. It is 12 feet 10 inches long, 36 inches wide and rated to 650 pounds, and it is the only Native kayak running the Propel X-Range Pedal Drive, which folds onto the bow deck when you want the cockpit back. It has its own Hammer 1210 review. Take the Falcon 11 for the lightest load and the simplest setup. Take the Hammer 1210 when you want both hands on the rod, a motor option and room for everything.
Native Watercraft Falcon 11 Questions, Answered
How much does the Native Falcon 11 weigh?
60 pounds for the fitted hull and 65 pounds fully rigged, at 11 feet long and 32.5 inches wide. It is the lightest kayak in the Native range.
What is the Falcon 11 weight capacity?
325 pounds. That includes you and everything you bring aboard, so add your weight, your gear and a battery if you run electronics before you decide. Most anglers running a light setup fit inside it with room to spare.
Can I stand and fish in the Falcon 11?
Native builds it with stand-up pads and a 32.5 inch beam. On calm water, standing to cast is normal. The Titan X kayaks are the wider all-day standing platforms in the line.
Can I run a fish finder on it?
Yes, and Native built for it. There is a transducer mounting plate on the hull, a console for the battery with transducer access, and gear track on the console cover for the display.
Can I add a pedal drive to the Falcon 11 later?
No. The Falcon 11 is a paddle kayak and Native's Propel kayaks are built around a drive well. If pedaling is where you are headed, start with a Propel kayak such as the Slayer Propel 10 LTE or the Hammer 1210.
What paddle length fits the Falcon 11?
With a 32.5 inch beam and a high seat position, most paddlers land at 240 to 250 cm. Taller paddlers and anyone who fishes from the high seat all day go to 250 or 260. The paddle sizing guide on our blog walks through it.
Does the Falcon 11 work with the Native Sidekick cart?
Yes. The Falcon 11 is groove-track equipped and Sidekick ready, so the Native Watercraft Sidekick Wheel Transport System mounts to the kayak and rides along with it.
How does the Native Watercraft Falcon 11 ship?
Two ways. If you are inside our delivery area, local delivery shows up as a shipping option at checkout and we bring the kayak to you ourselves. We call ahead to set a meet-up, and since we do the unloading there is nothing for you to inspect or sign at the curb. Otherwise it ships LTL freight with a carrier running a 99.9% damage-free rate. On a freight delivery, look the kayak over before you sign the receipt and write down any damage you see. That one step protects your claim. Then email clear photos to helpdesk@cfoutdoors.com within 2 hours. We email the full details once your order is placed.