YakAttack RotoGrip paddle holder and Omega rod holder kayak fishing accessories

Kayak Fishing Accessories: What to Rig First

Caney Fork Outdoors

A new fishing kayak comes out of the box with a seat, a few molded rod holders and maybe a stretch of track. Everything else is a decision, and the order you make those decisions in matters more than the brand on the box. The kayak fishing accessories that earn their spot first are the ones you touch every trip: a place to park the paddle, a rod holder you trust, a crate that holds the day's tackle, a way to hold position, and a flag so other traffic sees you. This guide walks the first rig in that order, with the YakAttack parts we carry for each job, and leaves electronics, lights and carts for their own articles.

One rule runs through all of it: mount to track, not to the deck. A track lets you move every accessory an inch forward when you change seats, swap a rod holder for a camera arm, or strip the kayak bare to sell it. Drilling a hole does none of that.

Start with the track

Most fishing kayaks ship with at least one length of factory track, and most of the accessories below click straight into it. Before you buy anything else, count the track you have and where it sits. The spots that fill up fastest are beside each knee and just ahead of the seat. If the factory track runs short, add some.

The YakAttack GTTL175 GearTrac 8" is the heavy-duty option: a top-loading aluminum track 1.75 inches wide that installs from the top side with thread-forming screws, so you do not need to reach behind the deck. The YakAttack GTTL90 GearTrac 8" is the medium-duty version at 0.90 inches wide and fits the same half-inch track hardware. Both take any YakAttack track accessory. Where you want a mount but not an aluminum rail, the YakAttack MightyMount XL 12" is a molded track 1.75 inches wide and 12 inches long that T-bolt accessories slide into from either end, and it installs with the included self-threading screws or with rivets.

If you have been searching for a kayak gear track or a kayak track mount, this is it: the rail is the track, and everything below mounts to it.

A paddle holder, before anything else

The first accessory to add is the one that keeps the paddle out of the water when both hands are on a rod. The YakAttack RotoGrip Paddle Holder is a soft roller that grips the shaft when you push the paddle in and releases when you pull it out, one-handed, without looking. It is 2.25 inches tall, comes with a MightyBolt, and fits GearTrac, MightyMount and most Scotty, RAM and YakGear track. A pair, one each side, is the standard setup; the YakAttack DoubleHeader with Dual RotoGrip Paddle Holders puts two on one track mount if you only have one open spot.

One rod holder you trust, then more

Molded-in rod holders hold rods in transit. A track-mounted rod holder holds a rod while you fish: trolling, soaking bait, or staging a second rig where you can reach it. Two YakAttack designs cover almost everyone.

The YakAttack Omega Rod Holder LockNLoad Track Mounting Base uses a 360 degree rotating collar that holds spinning, casting, conventional and fly rods, and the LockNLoad base has three modes: locked, adjust and remove. The YakAttack Zooka II Rod Holder LockNLoad Track Mounting Base is a tube holder with no moving parts that locks the rod by its shape, built for spinning, casting and conventional rods, and it ships with a 4 inch extension. Fly anglers go Omega. Everyone else picks by feel: the Omega adjusts the rod angle in a second, the Zooka II has nothing to break.

When the rod count grows, the YakAttack SideStage Rod Rack stages up to three rods horizontally along the gunwale on a pair of 14 inch ClickTrac rails, low enough to stay out of a pedal stroke or a bow motor. The YakAttack CenterStage Rod Stager with LockNLoad Mounting System stages up to four rods forward of the seat. The YakAttack Track Mounted Bullwinkle is the compact multi-rod stager with a slot for a measuring board.

Tackle storage that mounts to the kayak

A milk crate works until the first wave. The YakAttack BlackPak Pro Kayak Fishing Crate - 16" x 16" is a 16 by 16 by 13 inch crate with a hinged lid and CatchLatch closure, GridLoc panels on every side for mounting, and room for seven 3700 size boxes. It weighs 9.1 pounds bare and 11.5 pounds with six TetherTube rod holders fitted. It also comes in 13 by 16 and 13 by 13, so measure your tankwell and add about 2.75 inches per side if you plan to run the rod tubes. The crate article in December covers the three sizes in detail.

For a smaller kayak or a lighter day, the YakAttack TracPak Combo Kit, Two Boxes and Quick Release Base stacks two tackle boxes on a single track mount, 2.44 pounds for the kit, and the base also surface-mounts to a BlackPak Pro lid. The boxes are not waterproof and do not float, so they live where you can reach them, not where a wave can.

Hold position: anchor trolley and anchor reel

The difference between fishing a spot and drifting past it is an anchor trolley. The YakAttack LeverLoc Anchor Trolley runs 35 feet of reflective 550 paracord through Stealth Pulleys at bow and stern, with a LeverLoc clamp that fixes the anchor point anywhere along the side so you can set the kayak's angle to the wind or the current. All hardware and self-threading screws are included. The YakAttack LeverLoc Anchor Trolley HD adds backing plates for thinner decks.

The trolley moves the line. The YakAttack DropShot Anchor Reel holds it: 50 feet of 1/8 inch cord on a reel with an anti-reverse clutch and variable drag, in a 5.25 inch housing that mounts flat on 8 inches of track or at 45 degrees on 4 inches. It handles anchors from 2 to 12 pounds. The YakAttack Park N Pole 6' is the shallow water answer: a 6 foot fiberglass stakeout pole that floats, run through a scupper or a trolley ring to pin the kayak in two feet of water.

Be seen

The YakAttack VISIFlag is a 52 inch daytime visibility flag on a pole that drops into most tube-style rod holders or mounts to track. Tournaments require one, and on a busy lake it is the cheapest safety gear you will buy. Night lighting is its own topic; the VISIPole and VISI Light lines get an article of their own at the end of December.

Land the fish

The YakAttack Leverage Landing Net 12x20 with Foam Extension is built for a seated angler: a 12 by 20 inch hoop with full rubber netting on a folding handle with a locking trigger hinge, 56 inches overall, and a foam extension that stores in a tube rod holder. The forearm grip is the point. You net a fish with one hand while the other holds the rod. The YakAttack 16" x 19" Landing Net with 24" Long Telescoping Handle and Rubber Netting, Black is the lighter option at 1.4 pounds, with a handle that telescopes from 29.5 to 45.25 inches, and it floats.

The small stuff you will use every trip

The YakAttack Cup Holder Pro Orange is a kayak cup holder on a track mount that doubles as a base for six add-ons, from a bait tray to a trash lid, and it also comes as the YakAttack Cup Holder Pro Battleship Grey. The YakAttack RotoGrip Phone Holder with 1" Screwball Track Mount holds phones 2.75 to 3.625 inches wide in a one-hand roller grip, with a harness and coiled tether included. The YakAttack Surface Mount Retractor puts 36 inches of Kevlar cord on your pliers or grips so they come back when you drop them. The YakAttack Universal Scupper Plugs MD/LG (2 Pack) keep a wet seat dry on cold mornings, and the YakAttack Kayak Paddle Drip Rings keep the paddle from raining on your lap.

If you fish tournaments, the YakAttack LeaderBoard - 28" Measuring Board, Orange is the KBF-approved board with flip-out identifier holders and three cull tabs, and it floats.

What comes later

Electronics, a fish finder battery and the transducer arm are the next layer, and they get their own article on December 10; our YakAttack CellBlok review already covers the battery box. Getting the kayak to the water is covered in Kayak Carts: Suspenz and YakAttack, where the YakAttack TowNStow Bunkster Kayak Cart and the YakAttack TowNStow Scupper Kayak Cart live. The YakAttack MultiFlex Seat Cushion is in the seats article next week.

The First Rig List

  • Track: GTTL175 GearTrac 8" (heavy duty, 1.75 in), GTTL90 GearTrac 8" (0.90 in), MightyMount XL 12" (molded)
  • Paddle Holder: RotoGrip Paddle Holder, 2.25 in tall, one each side
  • Rod Holder: Omega (rotating collar, fly rod capable) or Zooka II (tube, no moving parts, 4 in extension)
  • Rod Staging: SideStage Rod Rack (3 rods), CenterStage Rod Stager (4 rods), Track Mounted Bullwinkle
  • Crate: BlackPak Pro 16 x 16 x 13 in, 9.1 lbs, seven 3700 boxes
  • Track Tackle Box: TracPak Combo Kit, two boxes, 2.44 lbs
  • Anchor Trolley: LeverLoc Anchor Trolley, 35 ft 550 paracord; HD adds backing plates
  • Anchor Reel: DropShot Anchor Reel, 50 ft of 1/8 in cord, 2 to 12 lb anchors
  • Stakeout Pole: Park N Pole 6', fiberglass, floats
  • Flag: VISIFlag, 52 in
  • Net: Leverage Landing Net 12x20 with Foam Extension, 56 in; 16 x 19 telescoping net, 1.4 lbs
  • Cup Holder: Cup Holder Pro, track mount, six add-ons
  • Phone: RotoGrip Phone Holder with 1" Screwball Track Mount
  • Tethers and Plugs: Surface Mount Retractor, Universal Scupper Plugs, Paddle Drip Rings

Key Features

  • Track First: Every accessory here mounts to GearTrac, MightyMount or factory track, so nothing is permanent.
  • Built for Life: YakAttack covers its molded parts with the Built for Life warranty.
  • One-Hand Operation: RotoGrip, LeverLoc and the Leverage Net are all designed to be worked with a rod in the other hand.
  • Made in the USA: The track, mounts, rod holders, cup holder and most of the small parts are made in the USA.
  • Modular: The Cup Holder Pro, BlackPak Pro and TracPak all accept add-ons as your rig grows.
  • Fits Other Track: LockNLoad and MightyBolt mounts fit most Scotty, RAM and YakGear track as well as GearTrac.
  • Hands-Free Positioning: Trolley, anchor reel and stakeout pole cover deep water, shallow water and current.
  • Visible: A 52 inch flag that fits a rod holder is the first safety upgrade.

Buy the track and the paddle holder with the kayak, add a rod holder and a crate before the first full day, and let the anchor trolley, net and the rest follow as the fishing tells you what you need. Everything on this page ships parcel, so it tends to arrive before a kayak does.

Kayak Fishing Accessories Questions, Answered

What kayak fishing accessories should I buy first?

Track if the kayak is short on it, then a paddle holder, then one track-mounted rod holder and a crate. Those four cover a full day of fishing. The anchor trolley, flag, net and cup holder follow as you find out what you reach for.

What is the difference between GearTrac and MightyMount?

GearTrac is an aluminum rail that accepts standard half-inch track hardware; the GTTL175 is the heavy-duty 1.75 inch version and the GTTL90 is the 0.90 inch version. MightyMount is a molded track that T-bolt accessories slide into from the ends. Both take every YakAttack track accessory.

Do YakAttack accessories fit the track that came on my kayak?

Most of them. LockNLoad bases and MightyBolt hardware fit GearTrac, MightyMount and most Scotty, RAM and YakGear track. A few kayak brands use a proprietary track that needs an adapter; the RotoGrip page lists the ones that do.

Omega or Zooka II for a kayak rod holder?

The Omega has a rotating collar that holds spinning, casting, conventional and fly rods and adjusts angle in a second. The Zooka II is a tube with no moving parts that locks a spinning, casting or conventional rod by its shape. Fly anglers need the Omega. Otherwise it is a matter of whether you want adjustability or simplicity.

Which BlackPak Pro size fits my kayak?

Measure the tankwell. The 16 by 16 crate is 15.94 inches square outside and 13.3 inches tall; the 13 by 16 and 13 by 13 are the smaller footprints. If you plan to run TetherTube rod holders on the sides, add about 2.75 inches per side to the footprint.

Do I need an anchor trolley if I have an anchor reel?

They do different jobs. The DropShot Anchor Reel stores and pays out the line. The LeverLoc Anchor Trolley moves the anchor point along the side of the kayak so you can set your angle to the wind or current. Run both and you store, pay out and position the line from the seat.

Can I install GearTrac without reaching behind the deck?

Yes. The GTTL175 and GTTL90 are top-loading and install from above with thread-forming screws, so you do not need hatch access. For the strongest install on a thin deck, YakAttack sells FullBack backing plates that go behind the track.

How do YakAttack accessories ship?

Ships parcel, nationwide. Everything on this list packs down small enough to box, so it goes out as a standard ground shipment.

Previous Next